EGW Docter to Smith & Wesson M&PRed Dot Mount

EGW red dot sightsare meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

EGW handgun mounts allow you to mount your Vortex Viper/Venom, Burris FastFire, or Docterred dot to your favourite handgun utilising the existing dovetail mount. These one piece HD mounts allow installation on some of the most popular handguns in Australia.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.Minor modification may be neccessary for Rock Islands. EGW’s products should be installed and checked by a qualified and competent gunsmith.

This mount will fit:Smith & Wesson M&P Full SizeSmith & Wesson M&P 2.0 Full SizeSmith & Wesson M&P 22 Full SizeSmith & Wesson M&P CompactSmith & Wesson M&P 2.0 CompactSmith & Wesson SD9VESmith & Wesson SD40VESmith & Wesson M&P ShieldThis mount does not fit:Smith & Wesson M&P C.O.R.E Series (Already Optics Ready)Smith & Wesson M&P Shield EZ .380Smith & Wesson M&P Shield EZ 9mmSmith & Wesson M&P .22 CompactSmith & Wesson SW9VESmith & Wesson SW40VE

The hole for the set screw on this mount is drilled off-center intentionally. This is to allow the set screw to be tightened against the bottom of the dovetail cut in the slide. This creates an upward force on the dovetail of the mount. If the hole were cut in the center of the dovetail, the set screw would fall through the hole cut in the center of the slide which would render the set screw useless.Smith and Wesson’s rear sight dovetails are known to vary in dimensions. Our sights are made to the same tolerances. Some users may have trouble installing our plate on their slide due to the varying tolerances in your slides. Please keep this in mind when ordering. Our return policy does allow for returns of unused and undamaged parts. These mounts should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Mounting Hardware:(2) 6-32 Button Head Screws(2) 6-32 Flat Head Screws(1) 6-32 Set Screw

Red Dot Fitment:Vortex ViperVortex VenomBurris Fast Fire 1, 2, 3, 4DocterADE RD3-001ADE RD3-002ADE RD3-009UTG Reflex Micro DotCrimson Trace CTS-1200Crimson Trace CTS-1300Sightmark Mini Shot

The mounting screws require a 5/64" wrench and the set screws (when applicable) require a 1/16" wrench.*All ADE mounts require 6-32 x 3/8" screws.